Digiplex DGP2-641BL Manual de Instalação descarregar pdf (Página 33)

Digiplex Modules Programming Guide - 33

Annunciator Module (DGP2-ANC1)

Outdoor High-Security Digital Motion Detector Module (DG85)

Remove B from any Annunciator that will have additional modules

stacked on top of it as shown in Figure 3 (below). Uppermost

Annunciators such as module 3 in Figure 3 or stand-alone modules do

not require the removal of B.

Remove the plastic square from keypad’s top back plate E.

Use a knife to cut away two holes approximately 75mm from the Annuciator’s

back plate. Cut a square in front of the guide clip (A) and at the top of the rim

(B). Dotted lines indicate cutting lines.

Connect wires to keypad or combus terminals.

Connect wires using A, B and the

guide clip on the Annunciator’s back

plate as shown in Figure 1 (above).

When the control panel’s locate

function is enabled, the first row of

green LEDs will flash.

The DG85 is designed for optimal performance at a height of 2.1m (7ft), but can be installed lower or higher. After you have installed the detector, ensure

that the PCB Height Markings match the installation height. The installation height is measured from the ground to the base of DG85's cover.

For example, if the motion detector is installed at a height of 2.1m (7ft), the PCB should then be adjusted to 2.1m (7ft). To adjust the PCB height, remove

the PCB screw and align the PCB Height Tab with the desired height marking on the PCB.

WARNING: Ensure that the unit’s front and back cover are tightly joined together, without any spacing around the rim of the unit, before tightening the

screw. Otherwise the weatherproof casing may be compromised and moisture may enter the unit.

PCB HEIGHT ADJUSTMENT

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 47 48

Comentários a estes Manuais

Sem comentários

Digiplex DGP2-641BL Manual de Instalação Página 33

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Digiplex DGP2-641BL