Digiplex DGP-641 Manual do Utilizador descarregar pdf (Página 19)

Digiplex Access Control 17

3.0 USING ACCESS CONTROL

3.1 ENTERING & EXITING

Depending on how your system is installed, there are various

ways to enter and exit through the Access Control Doors:

1) Present your Access Control Card to the

reader. The system will verify that the

card is allowed access according to its

assigned Access Level and Schedule. If

it is accepted, the system will unlock the

door. The reader’s light can be

programmed by the installer to turn

green or extinguish briefly to indicate

that the door can be opened.

2) When the motion detector detects movement (Request for

Exit event), it will unlock the door to permit passage with or

without turning the handle depending on its programming.

3) Enter your User Access Code on the keypad and press.

4) If the Access Control Door is on a “Door Unlocked Schedule”,

you may be able to open Access Control Doors without using

a User Access Code or an Access Control Card. Depending

on the door’s programming, the door can remain unlocked

during the entire programmed schedule or the door can

unlock once a valid Access Control Card is presented to the

reader during the schedule and then will remain unlocked for

the remainder of the schedule.

ACCKEU00.fm Page 17 Wednesday, November 24, 1999 11:05 AM

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 40 41

Sem comentários

Digiplex DGP-641 Manual do Utilizador Página 19