Digiplex DGP-641 Manual do Utilizador descarregar pdf (Página 13)

Digiplex Access Control 11

enter a User Access Code to disarm the area. For User Access

Codes assigned with the “Arm Only” User Option, option [8]

should remain off since they cannot disarm the partition(s).

For this feature to function properly, Option [2] “Disarm with

Access Control Card” on the User Access Code must be

disabled (see section 2.1.2, p. 9). If option [2] is enabled, access

will be granted and the area(s) will be disarmed without entering

a User Access Code. Access is only granted during the card's

assigned Schedule and to doors programmed in its Access

Level.

2.1.3 Card Assignment

The Access Control Card is activated by assigning its serial

number to the User Access Code. Either enter the serial number

manually or present the Access Control Card to the keypad’s

reader and its serial number will register automatically. The

serial number can be found on the Access Control Card.

2.2 PROGRAMMING U SER ACCESS C ODES

Your system can support up to 96 User Access Codes. User

Access Codes to be used with the Access Control system must

be programmed through an Access Control keypad.

This section will briefly show the steps required to program

codes. The Access Control features that can be programmed are

explained in section 2.1 on p. 8. For more details concerning

User Access Codes, refer to the Digiplex LCD Keypad User’s

Manual.

ACCKEU00.fm Page 11 Wednesday, November 24, 1999 11:05 AM

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 40 41

Sem comentários

Digiplex DGP-641 Manual do Utilizador Página 13