Digiplex DGP2-641BL Instruções de Operação descarregar pdf (Página 17)

LCD Keypad 17

7.0 TROUBLE DISPLAY

If your system experiences any

problems, “Trouble(s) [TRBL] to

View” will appear on the LCD

screen. The Trouble Display will

only display the troubles that

occur in the area(s) to which the

keypad has been assigned.

Potential troubles have been

sorted into eight groups. Only the troubles which are relevant to you are listed and described below. If a trouble that is

not described or listed below appears, contact your Installer.

We strongly suggest that if any troubles occur, contact your Installer immediately to have your

system serviced.

7.0.1 GROUP 1: SYSTEM

AC Failure

The control panel has detected a power failure. This means that your system is running on the backup

battery. If this trouble occurs when your establishment is not experiencing a power failure, call your

Installer for repairs.

Battery Trouble

The backup battery is disconnected, needs to be recharged, or replaced.

Bell Absent

The system has detected that the bell or siren is not connected.

7.0.2 GROUP 5: ZONE TAMPER

The zone(s) that was tampered with will be displayed on the LCD screen.

7.0.3 GROUP 6: ZONE LOW BATTERY

If a wireless device's battery needs to be replaced, the zone that is assigned to the device will be

displayed on the LCD screen.

7.0.4 GROUP 7: ZONE FAULT

A wireless device is no longer communicating with its receiver, or a connection or CleanMe

trouble is

occurring with your smoke detectors.

7.0.5 GROUP 8: CLOCK LOSS

The time and date have been reset to the default. This is the only trouble that we recommend that you

correct. “Clock Loss [8] to Set” will appear on the LCD screen after you press the [

TRBL] button. Refer to

section 8.3 on page 18 to set the time and date.

7.1 EVENT RECORD DISPLAY

Once you have entered Event Record Display mode, you can change the order that the Event Record screens

appear by pressing the [7] button. If you already know the number of the event you want to view, press the [

MEM]

button after step 3 above, and then enter the event's number.

The Event Record Display will

record the user-initiated

actions that occurred in your

system as well as any alarms

or troubles (i.e. “Access

Granted”). You will only be

able to view the events that

occurred in the area(s)

assigned to your User Access

Code.

How do I view the Event Record?

1) Enter your [

ACCESS CODE].

2) Press the [7] button.

3) If you have access to more than one area, select the area(s) you wish to

view (refer to section 2.3 on page 6).

4) Use the [S] and [T] buttons to scroll between the events.

5) Press the [CLEAR] button to exit.

How do I view the Trouble Display?

1) Press the [

TRBL] button when “Trouble(s) [TRBL] to View” appears on the

LCD screen. The Group Heading with the trouble will appear on the screen.

2) Press the [S] and [T] buttons to scroll between the Groups experiencing a

trouble.

3) Press the [

NUMBER] of the Trouble you wish to view.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Comentários a estes Manuais

Sem comentários

Digiplex DGP2-641BL Instruções de Operação Página 17

Comentários a estes Manuais